Before you start solving the issue of how to disassemble the iPhone 3GS, you need to understand that you carry out this operation only at your own peril and risk. If you inadvertently damage any parts, then the technical service may refuse to help you, and this happens in most cases. Therefore, we recommend that you first consider whether you will carry out repairs yourself or whether you should still trust the specialists.
Equipment required
In order to disassemble the iPhone 3GS, you will need to have a set of special tools on hand. The work will involve a collection of watch screwdrivers, a knitting needle or a plastic spatula with a thin end, however, you can also use a mediator. It will also require the use of a thin metal knife, but the presence of a scalpel is still recommended. Carrying should be used for better illumination supplyor table lamp. If you need to replace the protective glass on the screen of the device, in this case, be sure to have a hair dryer at hand.
Order
So, let's get down to the question of how to disassemble the iPhone 3GS. We will act in a certain sequence. If you use our instructions, in this case, be sure to remember that all points must be followed in strict sequence, otherwise you can only harm your device.
Display
The first thing you should do is inspect the iPhone. If you carefully studied it, then on the bottom end you will be able to notice two bolts, which must first be unscrewed. When this is done, you can open the screen unit, this is done as carefully as possible, otherwise the cables can be damaged. To remove this element, you can use a thin plastic or metal object, but we still recommend using a suction cup, so you do not damage the edges of the glasses. If you need to learn how to disassemble the iPhone 3GS, then in no case should you rush and be sure to follow the instructions. When the partially screen part is moved and raised, you should start by disconnecting the motherboard cable. The required element is located in the upper right part of the device. After this cable is disconnected, you should start disconnecting the second one, which is intended for the sensor. The third leads to dynamics. You must also turn it off for it to appear.the ability to completely detach the screen part. If everything is done correctly, then the module of interest to us will easily separate from the bottom of the device. Now you know how to disassemble the iPhone 3GS to replace the screen or protective glass, but if you need to continue the process, for example, to install a new motherboard or battery, then follow the steps below.
Deep repair
Pick up the bottom of the device. On the front side you can find screws, there are three of them on each side. We unscrew these elements and separate the display from the glass with the frame. In fact, care must be taken when separating the display. If you want to replace the glass, then you will need to heat it with a hair dryer, but if you do not plan to do this, we will not need to use a heater at all. Now you know how to disassemble the iPhone 3GS, and if you act strictly according to the instructions given, then you can do without the services of specialists and not damage anything, but on the contrary, fix the problem yourself. That's all we wanted to share in this article. Thank you for your attention to each user. We hope this guide will help you.
