Today, electronic gadgets are an integral part of the lives of almost all people in the world. Breakdowns often occur, and there are also malfunctions among the tablets. It is very important to know how to disassemble a Samsung tablet at home in order to fix defects in the device.
First you need to decide what you need to disassemble the gadget for. These devices are quite expensive, so the extra damage will be clearly unpleasant. Therefore, if there is no obvious need to disassemble the tablet, then you should not touch its internal structure.
Reasons
To figure out how to disassemble a Samsung tablet yourself, you need to list the factors that require this process. They can be as follows:
- Breakage or damage to one or more parts of the device. In the event of a fall, for example, external parts may remain intact, while internal ones may suffer. Therefore, if the gadget began to show defects in operation, you should disassemble it and find outreason.
- The element has lost its properties. Most often this happens with the battery. It eventually becomes less capacious and discharges faster. To replace it, you must disassemble the device and remove the battery.
- Interest. Many who are interested in how to disassemble a Samsung tablet may simply be interested in what is under the cover of the device. However, as already mentioned, you should not once again touch the inside of the gadget, so as not to damage them.
- Removal of a specific part. It often happens that some elements are taken from old devices and rearranged to new ones if necessary.
Preparation
Before the process, you should read the instruction manual that comes with the purchase. There may be information that is useful when disassembling the gadget. It will also not be superfluous to consult with familiar masters on how to disassemble the Samsung tablet with your own hands. You will also need additional equipment for the dismantling process.
Tools
We need:
- Set of small screwdrivers. The base must fit under the bolts on the device. You will need both a Phillips and a flathead screwdriver. You can also use watch tools, but good quality.
- Plates for electrical disassembly. Such tools are quite rare, so an ordinary knife or a plastic card will do as a replacement. But you need to be very careful with the knife so as not to damage the chips.
- Other tools: sharp knife, pliers,tweezers.
Process
When all the tools are prepared, you can proceed. It is recommended to write down or mark on paper where a certain part was located so as not to get confused during assembly. It would be even better to record the whole process on camera.
- You need to turn off the device. This item is extremely mandatory, since a sudden shutdown of the gadget as a result of disconnecting contacts will have a very negative impact on its further work.
- Inspect the back cover of the device. For some models, it is screwed to the base with several bolts, which must be unscrewed for further operations. If there are none, then you just need to pry off the cover with a knife or a plastic card and remove it.
- Now you can see many different microcircuits and mechanisms. The biggest part is the battery that needs to be pulled out.
- Now it will not be difficult to remove the motherboard, as it is no longer covered by a bulky battery. But first you need to disconnect the headphone jack, volume control mechanism, backlight element and screen data cable. It is also necessary to unscrew all the fixing bolts and remove the matrix.
First you need to remove all connected wiring from it, and then unscrew the bolt that holds this element. Using the same knife or a plastic card, pry off the battery and remove it from the device.
On thisthe main disassembly process is completed. Many who are concerned about the question of how to disassemble the Samsung tablet will be satisfied with this result. However, you can still remove some parts from the deep removal tool.
- On the motherboard, the camera is dismantled with a thin tool. They need to pry off the cable and disconnect the element.
- The front camera detaches in the same way as the rear camera.
- Now that the metal covers are removed, you can see the smallest microcircuits, as well as the processor of the tablet.
- How to disassemble a Samsung tablet completely? You also need to remove the display surface. This is done with a hair dryer. You need to warm up the front panel so that you can easily detach the screen.
This complete dismantling of the Samsung tablet can be considered complete.
Conclusion
As you can see, disassembling the tablet does not require hard-to-reach tools, and the process itself does not require special knowledge. Therefore, dismantling can be performed by anyone who is confident in his abilities. You just need to be careful and follow the recommendations and instructions exactly.
