This review will describe step by step the algorithm of how to set up channels on a Philips TV. And both digital and analog TV programs. In this case, the source of the transmission signal can be an on-air antenna or cable equipment. Usually, new owners of such devices are afraid of this operation and involve specialists to perform it for an additional fee. But by gradually performing the steps outlined in the future, it will not be difficult to implement it.
What are analogue and digital channels?
Before you set up channels on a Philips TV of any modification, let's figure out what format the programs are currently broadcasting in. Until recently, programs could only be watched inanalogue broadcast. With this approach, only one channel could be located at one frequency. The frequency range was subdivided into decimeter and meter. There were 60 such channels in total, and the maximum number of programs was limited to this number. Also, the quality of the resulting image was quite poor.
Now more and more broadcasts are going digital. In this case, TV programs are encoded in a special way and up to eight channels can already be on the same frequency. In addition to this, the picture quality improves significantly.
What do you need to take them?
Separately, it is also worth noting that some TV programs are broadcast in analog or digital format. In the first case, you need a regular tuner. And in the second case, the specifications of the multimedia center must contain the DVB-T2 marking. This means that the tuner in the device supports digital broadcasting.
Other TV programs in the form of a signal come from the equipment of various cable operators over the wires. In this case, the tuner must support DVB-C or DVD-C2 modes. Again, transmissions can be either analog or digital.
As a result, the old Philips TV cannot receive digital transmissions. It is not possible to tune channels on such devices for the reason that the tuner installed in them can only receive analog TV programs. But to receive digital transmissions, you needthere will be a prefix for signal decoding.
In other cases, it is enough to have a modern TV. You will also need a signal cable through which TV programs from the provider's equipment will be sent to the input of the device. You will also need an antenna to watch broadcast programs.
Assembling the TV. His connection
How to set up digital channels on a Philips TV of any current modification today? The first stage in such an operation is its assembly according to the attached instructions and switching.
After a new similar device is delivered, it must be taken out of the package and assembled. Next, it should be installed at the place of use. The next stage is the supply of communications. First, we bring the power cable, which will receive power from the power supply network. Then one end with a connector is connected to the corresponding socket of the multimedia system. And the second, on which the plug is located, is connected to the power outlet.
At the final stage, we bring the signal wire and install its plug into the ANT IN jack. With the help of the latter, a picture of TV programs will be sent to the multimedia center.
Software search
The next step is how to set up the Philips TV to receive channels in various formats. This is a search for available broadcasts using automatic mode. To do this, just turn it on, enter the main menu of the device and select the "Settings" sub-item. It needsselect the "Channels" section. Then select "Auto Search" in it. Next, you will be asked what signals the device should look for. Therefore, you need to set the type of connection: "Ether" or "Cable". We also set what format the received signal has - analog, digital or analog-to-digital. After that, the system will analyze the entire spectrum and find all available programs. This will take 10 to 15 minutes. As you can see, it is not so difficult to tune channels on a Philips TV. Next, you need to save the resulting list based on the scan results. After that, you can start using the multimedia center for its intended purpose.
Conclusion
In this review, we explained how to set up channels on a Philips TV. This algorithm is universal and can be used on any such entertainment system. It's fairly simple and shouldn't be a problem to run.
