There are still those who watch TV. And all this is contrary to common sense, since films are shown on TV already at a decent age, and local TV shows and series can be downloaded on the network a maximum of a day after their release. This article explains why the TV does not show. 100% - this is the chance that you will find a solution by reading this article.
The main reasons why the TV began to show badly
It is possible that this is an old habit of sitting on the couch, which certainly does not want to sink into the past. However, the unexpected appearance of a blue screen can noticeably fray the nerves of TV lovers until they figure out why the TV is not showing.
And the reason for this can be a number of factors.
- Bad weather or lack of a wave of the required frequency (relevant if you have analog or satellite TV and use an antenna).
- Technical obsolescence.
- Missing required settings or unsupported technologies.
Technical work on the TV channel or at the provider
All TV channels work around the clock, and the answer to the question of why the TV does not show may be both scheduled and unscheduled technical work. These are backup copies, equipment firmware, and much more. You can check the fact of technical work by switching to other TV channels. If everything is fine there, then all that remains is to wait.
Providers work in a similar way, and they also need preventive work.
Intervention by a local provider is also possible, which, for various reasons, could remove this TV channel from the list of its services without notice. In such cases, it is worth asking neighbors connected to other providers about the problems and finally figure out why the TV does not show channels.
Antenna or signal reception problems
The home television antenna is slowly becoming a thing of the past. More and more countries are switching to digital or cable television. These technologies do not use outdated technology for transmitting waves of the desired frequency over a distance and eliminate the need for "dancing with the antenna" in order to better catch the signal - all data is transmitted over wires with minimal loss of picture quality! An example is Ukraine, which has completely abandoned analogue television since September 2018.
Weak signal andthere is a reason why the TV does not show well. And this is, at a minimum, a terrible picture quality, as well as a limited number of channels. Whether it makes sense to replace the antenna with a more powerful one and with a small chance of increasing both of these factors depends on the specific case.
For example, outside the city it is unlikely to find a provider who will stretch a multi-kilometer cable to the village due to several subscribers. For him, this is unprofitable, and the payback will stretch for decades. The only way out in this case is a more powerful antenna or switching to satellite TV services.
Antennas, called dishes, are actively used in satellite TV technology. In this case, the weak receiver problem inherent in analog antennas can be completely eliminated. The reason why the TV does not show satellite channels may be a malfunction of the antenna itself.
Recent wind, hurricane, snow and other natural phenomena can also cause failures, which can damage the receiver, bend, unfold, tear off antenna parts, and also cover with snow, muffling the power of the receiver. In this case, it is necessary to inspect the device for cracks, traces of mechanical influences, and make sure that the antenna has not changed its slope.
If visually everything is in order, there is no rain or fog outside the window, and it is not possible to find out why the TV does not show, then it's time to contact subscriber support.
Technical failure
The last and rarest factor can be a broken TV. If onthe picture quality is poor on all channels, everything is fine with the neighbors, and technical support cannot help, most likely, the TV is out of order.
