It's time to buy a new phone. It would be more accurate to say a smartphone. Phones are slowly becoming obsolete. This is due to the fact that the functionality that the phone carries is too small. But a smartphone, which means “smart phone” in English, will help you in almost any situation. Manufacturers, in order to extend the life of the device by several hours on a single charge, insert a larger battery there. Because of this, it turns out that a regular SIM card cannot fit there. Therefore, they began to use microsim. So that you don't panic, I will teach you how to make a microsim.
There are two ways to make a microsim. The first one is perhaps the easiest. You just need to find the documents and go with the old SIM card to the communication salon of the operator that serves you, and there you will be replaced without any problems. It won't take very long. Most companies will do this for free.
The second way is a little harder and more dangerous. You will have to make a microsim from the sim card you used before. In fact, it will take you about 5 minutes. To perform these steps, you only need scissors, a pencil and a ruler. And yes, I almost forgot, a littlepatience. Standard SIM card size: 2x15x0.76 mm. But the newly minted microsim has slightly smaller parameters: 15x1x0.76 mm. We're all lucky the width didn't change.
Now draw a 15x12mm rectangle around the metal chip. Draw so that you can see later when you start cutting. Once everything is ready, proceed to the operation. Start cutting carefully. Use larger scissors. Manicure ones will not work at all, since the plastic is quite thick and durable. How to make microsim more accurate? You can sharpen it a bit with a nail file. But in no case do not use a file. In this case, the most important thing is that the edges are even, and the internal chip is not damaged.
Congratulations! Now your microsim is ready. You can safely insert it into your smartphone. But be careful. Some tablets do not receive calls, they are only designed to access the Internet, so you should not convert the old SIM card into a new standard card. Better go to the salon and get a SIM card with a special rate.
As a rule, only one company uses such cards. But more recently, they switched to nanosim. And this is even less than microsim. But I strongly recommend that you go to a communication salon and change your SIM card there, because it's much easier. Also here you can ask how to make microsim yourself. But in most cases they will tell you to change it. As mentioned above, not all manufacturers use microsim. If youused a smartphone in which there was a microsim, and now they bought one where the usual one, you should not stick everything back. You can change it in the communication salon. And also conscientious manufacturers put some kind of adapter in the box with a smartphone. You insert a microsim there and you get a regular sim card. Everything is very simple and fast. Of course, you can buy this miracle in any relevant store.
Now you know how to make a microsim from a regular SIM card, and made sure that there is nothing complicated about it. The most important thing is patience. Good luck!
